Bearing Base
HT250
67x55mm

High purity;
 Excellent machinability;
 High dimension precisions, small machining allowance and excellent machined surface finish;
 Remarkable improvement in tenacity and fatigue-resistance; 
 High and uniform density; excellent pressure-tightness; 
 Heat Treat Response
 Thermal Conductivity
 Vibration Damping
 Wear Resistance
 Weight Reduction
 Corrosion Resistance
 Cost Effective

When sand cast irons were originally used, the reject rate is as high as 30% to 70% averagely, and even totally rejected. After continuous cast iron bar are used, the reject rate is reduced greatly. Better machined surface finish and higher dimensional precision are achieved. The produced parts perform excellently. No material wastes are found.

Since continuous cast iron material has the typical fine grains in dense homogeneous matrix, this ensure its suitability in applications demanding the ability to withstand high pressures without leaking.

Since our company is equipped with complete series of machining facilities, we can produce and supply you machined parts according to your drawings.

We also provide OEMs and Custom-Made. We manufacture not only our own fashions, but also as per your designs / samples.

If you are a wholesaler, distributor, retailer, or manufacturer, we would like to act as your overseas vendor to manufacture according to your design / sample and under your label and logo.